XYCRYLIC ADMIX is a water-based, high solids, polymer dispersion specifically designed for fortifying Portland cement compositions.
This liquid is milky white in colour and improves curing qualities, enhances bond, imparts excellent water and weather resistance, and reduces shrinkage cracking. Xycrylic Admix is also used to fortify Xypex Patch’n Plug.
Xypex Quickset is a water-soluble liquid blend of silicates, neutralizers and penetrating agents specially compounded to harden, dustproof and seal the surfaces of fresh or newly cured concrete floors.
Applied to the concrete surface, Xypex Quickset penetrates into the capillaries of the concrete substrate and chemically reacts with the free lime and calcium carbonate to form a hard, insoluble gel within the pores, thus closing off the small voids. Quickset provides superior hardening and a dustproof finish.
Xypex Australia provides complete concrete repair and protection solutions, the following high quality products are available to complete the Xypex system.
XYPEX GAMMA CURE is a curing agent designed specifically for Xypex crystalline waterproofing products. Gamma Cure may be used as an alternative to water curing for certain Xypex applications. It is also used to accelerate the Xypex Crystallization Process.
Xypex Gamma Cure acts as an evaporation retardant by retaining the maximum amount of moisture in the Xypex coating. It also provides a catalyst for the reaction with the Xypex crystalline waterproofing treatment. It is a self-dissipating (2 – 3 days) non-film forming product.
M P&P Mortar is a fast setting, non-shrink mortar for concrete repairs where waterproofing is a requirement.
M P&P Mortar is used for sealing cracks to stop water flows, and other defects in concrete. It is also used to seal tie bolt holes.
For ease of opening pails.
Flupp 22ST is a non- rigid PVC internal water seal for spacer tubes, where the internal diameter is 22mm.
Resistant to:
- Saline Solutions
- Diluted Alkaline Solutions
- Soap Suds
Silica Fume is a high performance, densified silica fume powdered product, derived as a by-product from the production of Ferro Silicon using the arc furnace method. Used in pre-mixed concrete for enhancing mechanical properties of concretes with special performance requirements, including increased strength, reduced permeability, improved abrasion resistance and increased corrosion resistance.
Silica fume consists of very fine particles. Because of its extreme fineness and high silica content, silica fume is a highly effective pozzolanic material. Being a highly reactive pozzolan, silica fume chemically reacts with the calcium hydroxide present in the cement paste, creating a stronger calcium silica hydrate ‘making it sticky’Âť. The result is improved paste to aggregate bond (excellent for shotcrete) and higher concrete strengths. Silica Fume is typically grey in colour and is categorised as a supplementary cementitious material (SCM). Silica Fume is compliant to AS/NZ 3582.3:2002 and is described as a Densified Amorphous Fumed Silica.
Kuniseal C-31 DS has been developed as an easy-to-use bentonite clay swelling waterstop material designed to prevent the ingress of water through cast-in-situ concrete construction joints.
News
Repair and Remedial
XYPEX CONCRETE WATERPROOFING BY CRYSTALLIZATION™ products have been successfully applied worldwide for more than forty years,
Read more
Dryshake
Xypex dry shake product is used for horizontal surfaces, applied while concrete is still green.
Read more
Coatings
Xypex Concrete Coating products are for surface application directly onto clean, bare and damp concrete surfaces.
Read more